By | 09.01.2019

Rather key switch hook up think, that you

HOW TO WIRE AND INSTALL AN IGNITION SWITCH PANEL!

Universal ignition switches are used on off-road vehicles, boats, generators and industrial equipment. They are durable and easy to install, but they offer very little in the way of security. Wiring is straightforward, with threaded studs on the back of the switch over which eyelet connectors fit, and the eyelets are held in place by tightening small nuts. A high-quality design switch will last for decades, and because of their broad application, these switches are likely to be in use well into the future. Draw a wiring schematic. This is critical for a successful job. The back of the switch is marked with the function of the switch.

The accessories part of the ignition powers the accessories part of the fuse panel, such as radio, park lights and hazard flashers. The run wire powers the entire fuse panel.

Big Shoutout, Electric EZGO to gas UTV, key switch, wire harness,

The start wire only supplies two circuits: Use different color wires, and select wires that are heavy enough to power the circuits. The run wire should be gauge, the accessories wire gauge, and the start wire gauge.

Key Switch Installation

Install the wire on the ignition switch and tighten the retaining screws with a wrench. Route the wires to the fuse box location and install the wires on the box. Different fuse panels have different attachment methods. Universal fuse panels often have studs that secure the wires with attachment nuts. Tighten the wires in place with a wrench.

Key switch hook up

Jack Hathcoat has been a technical writer since His work includes instruction manuals, lesson plans, technical brochures and service bulletins for the U. Hathcoat is an accredited technical instructor through Kent State University and certified in automotive service excellence. Items you will need Wire strippers Wire cutters Crimp tool Wrench set. Determine which one is appropriate for your ignition switch.

Connect the accessory lead wire to the "ACC" terminal of the ignition switch using the appropriate wire terminal.

This wire energizes vehicle accessories such as the radio when the ignition switch is turned to the "ACC" position. Connect starter relay wire to the "ST" terminal of the ignition switch. Connect the ignition wire to the "IGN" terminal of the ignition switch. This is the main terminal that is used for vehicle ignition, wipers, accessories and other operating features.

This is the normal "run" position of the switch. Michelle Schaefer began writing in for "The Pennsylvania Homeschooler" with advice for parents educating their handicapped children at home.

She earned a bachelor's degree in education from Kutztown University in Reconnect the cable to the negative battery terminal. Items you will need Adjustable wrench Cross-tip screwdriver Terminal connectors Terminal multi-tool.

3 comments

  1. Shasho

    You are not right. I am assured. Let's discuss.

    Reply
  2. Shaktigrel

    I apologise, but, in my opinion, you commit an error. Let's discuss it. Write to me in PM, we will talk.

    Reply

Leave a Reply

Your email will not be published. Required fields are marked *